These are throttle control grips with an integrated LED display and key start switch, designed for electric bikes, scooters, and tricycles that use grip-based speed control. The grips replace standard handlebar grips and provide direct control over acceleration along with basic system feedback.
They’re typically used on utility e-bikes, mobility trikes, and electric scooters where simple speed control and keyed power-on are required.
Key Features
• Integrated LED display for speed setting and system status
• Twist-grip throttle speed control
• Built-in key start switch
• Pair of left and right grips
• Designed as a combined grip and control assembly
Compatibility & Use Notes
• Handlebar diameter: 22.2mm (standard e-bike / scooter size)
• Intended for electric bikes, scooters, and tricycles with compatible controllers
• LED display function depends on controller support
• Key switch wiring must match controller requirements
• Not compatible with pedal-assist-only bicycles
• Not compatible with hydraulic motorcycle throttles
Service / Ownership Context
Throttle-and-display combinations are not standardized across e-bike systems. Connector types, voltage ranges, and signal expectations vary by controller. Before installation, connectors and pin layouts should be verified. After install, throttle return and full shutoff should be tested with the wheel off the ground.
Fit & Use Signals
• Good fit for electric bikes, scooters, or trikes using grip-based throttles
• Good fit if your setup requires a keyed start switch
• Good fit for utility or mobility-focused electric vehicles
• Not a fit for bicycles using only pedal assist
• Not a fit if your controller does not support LED display or key input
